Gai-tronics VoIP Telephone Software Configuration Guide Manual de usuario descargar pdf (Pagina 74)

GAI-TRONICS

VoIP Telephone Configuration Guide Page 74 of 88

9.2 ACCESS Module Command Line Syntax

Action

Verb

Parameters

Comment

1 2

SET

USERNAME UserName

Sets the user name used in local or remote access to

be “UserName”. UserName can be up to 30

characters long, and can contain only the

alphanumeric characters a-z, A-Z , 0-9 . The default

value is “user”. The Username cannot be blank.

IMPORTANT: The word ‘root’ is a reserved

username and must not be used or assigned a

password. Setting a user name of "root" will make it

impossible to access the phone, and will require a

reset to factory defaults.

PASSWORD <Password>

Sets the password used in local or remote access to

be “Password”. <Password> can be up to 30

characters long, and can contain only the

alphanumeric characters a-z, A-Z , 0-9 . The default

value is password.

QUIT

This command returns the user to the login prompt,

effectively logging the user out and returning the CLI

to the secured state.

EXIT

This command returns the user to the top level of the

Command line Interface

SHOW ALL

Shows the current access Name and Password and

also the access error counters

RESET COUNTERS Resets the access error counters

Note: please make sure to record the user name and password securely. They will be

required to access the phone every time whether by web page, command line or

configuration file.

In the event that the username and password are lost, the unit will need to be reset to

factory defaults. This can be done by holding down a button on the main circuit board.

See section 10.

3XED

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 87 88

Comentarios a estos manuales

Sin comentarios

Gai-tronics VoIP Telephone Software Configuration Guide Manual de usuario Pagina 74

Comentarios a estos manuales

Relacionado con productos y manuales para Comunicación Gai-tronics VoIP Telephone Software Configuration Guide