Gai-tronics L3149B C200 Advanced Deskset Manual de usuario descargar pdf (Pagina 19)

L3149B (C200) Advanced Tone Remote Desk Set Operation

VOLUME Up and VOLUME Down Buttons

Press the VOLUME Up or Down buttons to adjust the local speaker volume if the handset is on-hook. The

handset speaker volume is adjusted if the handset is off-hook.

The display shows the new setting for 2 seconds after a volume change. The internal, handset, and

accessory each have individual settings. When the handset is off-hook, the following message is

displayed:

HANDSET VOL: X

The VOLUME Up and VOLUME Down buttons adjust the sensitivity of the microphone that is currently in

use. While holding down the

TRANSMIT button, handset PTT bar, or the accessory PTT, press the

VOLUME Up or VOLUME Down buttons. This display will indicate the MIC SENSITIVITY setting in a

range of 1 to 5 with 1 being the least sensitive and 5 the most sensitive. Note that each microphone,

internal, handset, and accessory each has its own independent sensitivity setting. Refer to the Settings and

Adjustments in the Installation section of this manual for more information.

Pressing the

LOCK + VOLUME Up buttons will activate the internal speaker when the handset is off-hook.

This can be used if others must hear the conversation. When the handset is returned to the cradle, this

setting is reset so that if the handset is again removed from the cradle, the internal speaker is not active.

Pressing the

LOCK + VOLUME Down buttons will mute the internal speaker indefinitely. Pressing

VOLUME Up, VOLUME Down, LOCK + VOLUME Up, or removing the handset from the cradle and

returning it will reset this setting.

LOCK Button

The LOCK button is used in conjunction with other buttons for additional button operation.

IC (Intercom) Button

To communicate between desk sets without transmitting over the radio channel, press and hold the IC

button. Microphone audio is routed to the line without activating the radio transmitter. Other desk sets on

the same line will hear the audio automatically. Note that when configured for 4-wire operation, the

internal intercom path must be enabled by the programming software for parallel units to hear intercom

audio.

MONITOR Button

When the MONITOR button is pressed, the desk set, adapter, and the radio are placed in the monitor mode

(PL/DPL disabled), the

MONITOR LED illuminates, and the display indicates MON. Press this button

before making a call to ensure a clear radio channel is available.

TRANSMIT Button

Press this button to place the desk set in the transmit mode. See the Initiating Calls section. When the

TRANSMIT button is pressed and a channel has been established, the TRANSMIT LED illuminates, and

MONITOR LED (if lit) extinguishes. The display indicates the mode and current frequency selected.

Keypad Buttons

The numeric keypad is used for various uses including the selection of a desired frequency, page capcode

entry, and MDC1200 ID entry. See Numeric Keypad Frequency Selection in this section of the manual

for further information.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 91 92

Comentarios a estos manuales

Sin comentarios

Gai-tronics L3149B C200 Advanced Deskset Manual de usuario Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Comunicación Gai-tronics L3149B C200 Advanced Deskset