Gai-tronics ILD1000A Local Deskset User and Installation Manua Manual de usuario Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
7 02/12
Operation
Front Panel Button Operation
VOLUME Up/Down Buttons
Press the VOLUME Up or VOLUME Down buttons to adjust the local speaker volume. They are also used
as programming function keys.
(CTL) Control Button
The CTL button is used in conjunction with the VOLUME Up and Down buttons to manually control the
local speaker. Press and hold the
CTL button, and then press the VOLUME Up or VOLUME Down button.
IC (Intercom) Button
Press the IC button to communicate between desk sets without transmitting over the radio. When the IC
button is pressed and held, microphone audio is routed to the line without activating the radio transmitter.
Other parallel desk sets will hear the audio automatically.
MONITOR Button
Press the MONITOR button (CTCSS/CDCSS disable) to place the radio in the monitor mode. Press this
button before making a call to verify a clear radio channel is available.
TRANSMIT Button
Press the TRANSMIT button to place the desk set in the transmit mode and initiate voice transmissions.
With the handset on-hook, transmit audio is picked up from the internal microphone.
Receiving Calls
Local Speaker
When power is applied, the desk set is in the receive mode, allowing receive audio to be heard through
the speaker or handset. The desk set is always in receive mode unless the user presses the
TRANSMIT or
IC buttons.
The desk set contains an internal (local) speaker and a handset speaker, which operate as follows:
When the handset is in the cradle, or on-hook, receive audio is heard on the local speaker.
When the handset is off-hook, receive audio is routed to the handset.
Muting the Local Speaker: Press
CTL + VOLUME Down to mute the local speaker. The selected
frequency button flashes to indicate that the speaker is muted. Unmute the speaker by pressing
VOLUME Up, VOLUME Down, or CTL + VOLUME Up.
Press
CTL + VOLUME Up to enable the local speaker while the handset is off-hook. When the handset is
placed back on-hook, the local speaker again operates normally– that is, it will be disabled whenever the
handset is taken off-hook.
Vista de pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comentarios a estos manuales

Sin comentarios