Gai-tronics TMA Version 7.5.0 Telephone Management Application Manual de usuario descargar pdf (Pagina 19)

Pub. 42004-479B

Telephone Management Application (TMA) User Guide Page 16 of 128

e:\standard ioms - current release\42004 instr. manuals\42004-479b.doc

03/14

Complete the following procedure at the telephone site location. Print the form in Table 3 below.

Table 3. Auto-Discovery Procedure

Step Explanation of Step Actions Installer Actions

1 Connect the phone line to the Type A telephone at its site

location. Wait 30 seconds.

Connect Tip/Ring.

Wait 30 sec.

2 The following steps use “local” access programming (keypad required). Refer to GAI-

Tronics Pub. 42004-438 (available on www.gai-tronics.com

) for further instructions.

 Type A telephones that do not include an integral keypad will require the use of a No.

51035-011 Keypad and No. 61504-048 Keypad Cable Assembly. The keypad and cable

must be connected to J13 on the PCBA.

 The CALL push-button connector J1 is exclusively used for local programming. Type A

telephones that include only the EMERGENCY push button must temporarily have the

associated switch harness plug moved from the EMERGENCY connector J7 to the CALL

push-button connector J1 on the PCBA.

3 Press the CALL or EMERGENCY push button (whichever is

connected to J1).

When the dial tone is heard from the speaker,

simultaneously press the “1” and “#” keypad buttons.

 If the telephone is in its factory-programmed Standard

Mode, the telephone generates a splash tone

(low to high sequence), followed by a success tone

(short beep).

 If the telephone has previously been used with TMA, it

generates only a success tone (short beep).

Press J1 button, then 1 + #

[ tone(s) ]

4 Immediately after the success tone, use the keypad and

press

*** to enter Programming Mode.

* * * [no tone]

5 Wait 2 seconds. Wait 2 sec.

6 Using the telephone’s keypad enter **0000 to gain access

with the factory-default password.

* * 0 0 0 0 [no tone]

7 Next, enter *127 followed by the phone number of the

telephone. When finished, press #. The telephone outputs

a success tone (from the speaker of hands-free phones, or

the earpiece at handset phones) to acknowledge the entry.

*1 2 7

_ _ _ _ _ _ #

[ one tone]

8 After the success tone, enter *123 followed by the

telephone number assigned to the TMA DTMF

Transceiver. When finished, press #. The phone outputs a

success tone to acknowledge the entry.

*1 2 3

_ _ _ _ _ _ #

[ one tone]

9 After the confirmation tone, enter *99 to end the set up.

The telephone outputs a success tone to confirm

completion of the entry.

*9 9

[ one tone]

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 130 131

Comentarios a estos manuales

Sin comentarios

Gai-tronics TMA Version 7.5.0 Telephone Management Application Manual de usuario Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Comunicación Gai-tronics TMA Version 7.5.0 Telephone Management Application