Gai-tronics 12593-101 Redundant PPI Switching Module Manual de usuario descargar pdf (Pagina 3)

Pub. 42004-474A

Model 12593-101 Redundant PPI Switching Module Page 3 of 5

f:\standard ioms - current release\42004 instr. manuals\42004-474a.doc

04/13

The following is a summary of each connector and terminal block function(s):

J1 – A-IN (RJ45 jack) J2 – B-IN (RJ45 jack)

Pin No. Function Pin No. Function

1 & 2 Page Line 1 & 2 Page Line

3 & 6 Party Line 1 3 & 6 Party Line 1

4 & 5 Party Line 2 4 & 5 Party Line 2

7 & 8 Control input (CLS) 7 & 8 Control input (CLS)

J3 – OUT (RJ45 jack) TB1 – 12 V dc Power Input

Pin No. Function Terminal No. Function

1 & 2 Page Line 1 12 V (−)

3 & 6 Party Line 1 2 12 V (−)

4 & 5 Party Line 2 3 12 V (+)

7 & 8 Control input (CLS) 4 12 V (+)

TB2 – Switching Control Input TB3 – Relay Contact Output

Terminal No. Function Terminal No. Function

1 Control Line (active low) 1 Normally Close

2 Control Line (active low) 2 Common

3 Normally Open

Address Switch Settings

Address switches S1 and S2 on the upper CPU PCBA must each be set to position F for a board address

of FF. When using multiple modules, address FF must be set on ALL modules. Address FF allows the

module to operate as a Multi-Station Simulator (MSS), with its designated PPI cards. Refer to the

operation section for information on the MSS feature.

1 2 3 4 5 6

Sin comentarios

Gai-tronics 12593-101 Redundant PPI Switching Module Manual de usuario Pagina 3