Gai-tronics SPK200 Solar Panel Interface Kit Manual de usuario descargar pdf (Pagina 2)

Pub. 43003-039A

ODEL SPK200 SOLAR INTERFACE KIT Page: 2 of 3

d:\radio products-current release\43003\43003-039a\43003-039a.doc

06/05

Installing the Charge Regulator Module and Interconnection

1. Referring to Figure 1, remove the four screws from the front of the XB001 enclosure (mounted or not

mounted). Open the front cover to the left and pull straight out until the hinge pins separate from the

rear section. Set the front door of the enclosure aside.

Figure 1. Exploded view of the External Battery Enclosure with Charge Regulator Module

2. To prepare for the solar panel cable entry, drill a 0.492-inch hole into the bottom of the enclosure at

one of the two drill spots (dimple provided). Install the provided bushing into the hole.

3. Install the 2-point terminal block using the #6-32 × .187 inch (3/16-inch) screws provided.

4. Install the charge regulator module using the #6-32 × .500 inch (1/2-inch) screws provided.

5. Install the harness assembly provided, carefully adhering to the color-coding depicted in Figure 2, the

interconnection diagram.

1 2 3

Sin comentarios

Gai-tronics SPK200 Solar Panel Interface Kit Manual de usuario Pagina 2