Gai-tronics ICS Page/Party Remote Subset Handset/Speaker Ampli Manual de usuario descargar pdf (Pagina 2)

Pub. 42004-725L2HQG

ICS Class I, Div. 2 Page/Party

Station Quick Installation Guide Page 2 of 2

f:\standard ioms - current release\42004-xxxxqg quick guides\42004-725l2hqg.doc

03/15

Available Adjustments

Most optional equipment is preconfigured to a default standard at the factory. The

following is a partial list of the available adjustments and settings that may be

needed:

Main PCBA VLC Option SmartSeries Option

 Speaker Volume  Speaker Volume  FSK Transmit Level

 Receiver Volume  VLC Override  Address

 Transmit Level  Test Tone

 Mutual Muting  Page Control

Termination PCB

 Remote Signaling  Speaker impedance

Figure 3. Typical installation wiring configuration

OTE: Station input power can be through system cable or through a separate power source cable.

See Pub. 42004-725L2 for the possible beacon, RTU activation, and speaker impedance configurations.

Front Cover Reattachment

Connect any cable harnesses that were disconnected during mounting. Place the front cover on the rear enclosure, being careful not to pinch

any cables. Attach the front cover with the four screws and washers provided. Torque the screws to 10–12 in-lbs (1.13–1.36 n-m).

NEMA 12

NRTL Listed for USA and Canada ................................................................................................... Class I, Groups A, B, C, and D, Division 2;

Class II, Groups F and G, Division 2;

Class III, Division 2 Hazardous Locations

Temperature code, T4A - USA

T3C - Canada

Figure 2. Suggested wire entry locations

1 2 3

Comentarios a estos manuales

Sin comentarios

Gai-tronics ICS Page/Party Remote Subset Handset/Speaker Ampli Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Comunicación Gai-tronics ICS Page/Party Remote Subset Handset/Speaker Ampli